Modeling and Analysis of a Hybrid Photovoltaic-Thermoelectric Solar Cavity-Receiver Power Generator

Document Type : Research Article

Authors

Department of Mechanical & Energy Engineering, Shahid Beheshti University, Tehran, Iran

Abstract

In the present paper, a cavity configuration for the hybrid photovoltaic-thermoelectric generator is proposed and investigated theoretically. The cubical cavity-receiver is packed with five photovoltaic modules and four thermoelectric generator modules which are stacked at the backside of each photovoltaic module. The solution algorithm using the equations of heat transfer and generated power of photovoltaic and thermoelectric generator modules is developed via MATLAB and simulated under various irradiation levels. It is shown that under 1000 W/m2 irradiation, the hybrid system can produce 536 mW which is 2.4 times the photovoltaic-thermoelectric generator alone. After modeling the system with fully open aperture, the cavity with a small aperture modeled to investigate the opening size effect on the hybrid system under non-concentrating irradiation. The results show the efficiency improvement of 27% by applying small aperture in the opening of the cavity. Although the efficiency is increased by decreasing the aperture size, the total generated power for the wide aperture is larger than the generated power in the cavity with a smaller aperture due to more radiation absorption. By balancing between minimum re-radiation loss and maximum irradiation absorption for the cubic cavity, one can conclude that the optimum aperture opening area is 42.7% of cavity surface area.

Keywords

Main Subjects


[1] A.A.J. Muto, Thermoelectric device characterization and solar thermoelectric system modeling, MassachusettsInstitute of Technology, 2011.
[2] J. Tonui, Y. Tripanagnostopoulos, Performance improvement of PV/T solar collectors with natural air flow operation, Solar Energy, 82(1) (2008) 1-12.
[3] G. Rockendorf, R. Sillmann, L. Podlowski, B. Litzenburger, PV-hybrid and thermoelectric collectors, Solar Energy, 67(4-6) (1999) 227-237.
[4] W. He, J. Zhou, C. Chen, J. Ji, management, Experimental study and performance analysis of a thermoelectric cooling and heating system driven by a photovoltaic/ thermal system in summer and winter operation modes, Energy conversion and management, 84 (2014) 41-49.
[5] L. Tayebi, Z. Zamanipour, D. Vashaee, Design optimization of micro-fabricated thermoelectric devices for solar power generation, Renewable Energy, 69 (2014) 166-173.
[6] D. Kossyvakis, G. Voutsinas, E. Hristoforou, Management, Experimental analysis and performance evaluation of a tandem photovoltaic–thermoelectric hybrid system, Energy Conversion and Management, 117 (2016) 490-500.
[7] Y. Vorobiev, J. González-Hernández, P. Vorobiev, L. Bulat, Thermal-photovoltaic solar hybrid system for efficient solar energy conversion, Solar Energy, 80(2) (2006) 170-176.
[8] E. Chávez-Urbiola, Y.V. Vorobiev, L. Bulat, Solar hybrid systems with thermoelectric generators, Solar energy, 86(1) (2012) 369-378.
[9] H. Najafi, K.A. Woodbury, Modeling and analysis of a combined photovoltaic-thermoelectric power generation system, Journal of Solar Energy Engineering, 135(3) (2013) 031013.
[10] S. Soltani, A. Kasaeian, H. Sarrafha, D. Wen, An experimental investigation of a hybrid photovoltaic/ thermoelectric system with nanofluid application, Solar Energy, 155 (2017) 1033-1043.
[11] Y. Deng, W. Zhu, Y. Wang, Y. Shi, Enhanced performance of solar-driven photovoltaic–thermoelectric hybrid system in an integrated design, Solar energy, 88 (2013) 182-191.
[12] J. Zhang, Y. Xuan, L. Yang, Performance estimation of photovoltaic–thermoelectric hybrid systems, Energy, 78 (2014) 895-903.
[13] X. Ju, Z. Wang, G. Flamant, P. Li, W. Zhao, Numerical analysis and optimization of a spectrum splitting concentration photovoltaic–thermoelectric hybrid system, Solar Energy, 86(6) (2012) 1941-1954.
[14] J. Zhang, Y. Xuan, L.Yang, A novel choice for the photovoltaic–thermoelectric hybrid system: the perovskite solar cell, International Journal of Energy Research, 40(10) (2016) 1400-1409.
[15] F. Willars‐Rodríguez, E. Chávez‐Urbiola, P. Vorobiev, Y.V. Vorobiev, Investigation of solar hybrid system with concentrating Fresnel lens, photovoltaic and thermoelectric generators, International Journal of Energy Research, 41(3) (2017) 377-388.
[16] H. Najafi, K.A. Woodbury, Optimization of a cooling system based on Peltier effect for photovoltaic cells, Solar Energy, 91 (2013) 152-160.
[17] Y.-Y. Wu, S.-Y. Wu, L. Xiao, Management, Performance analysis of photovoltaic–thermoelectric hybrid system with and without glass cover, Energy Conversion and Management, 93 (2015) 151-159.
[18] C. Suter, P. Tomeš, A. Weidenkaff, A. Steinfeld, A solar cavity-receiver packed with an array of thermoelectric converter modules, Solar Energy, 85(7) (2011) 1511- 1518.
[19] J.R. Howell, M.P. Menguc, R. Siegel, Thermal radiation heat transfer, CRC press, 2015.
[20] S. Lin, E. Sparrow, Radiant interchange among curved specularly reflecting surfaces—application to cylindrical and conical cavities, Journal of Heat Transfer, 87(2) (1965) 299-307.
[21] A. Steinfeld, Apparent absorptance for diffusely and specularly reflecting spherical cavities, International journal of heat and mass transfer, 34(7) (1991) 1895- 1897.
[22] J.R. Howell, Catalog of Radiation Heat Transfer Configuration Factors, in, 2010.
[23] J.F. Hinojosa, C.A. Estrada, Three-dimensional numerical simulation of the natural convection in an open tilted cubic cavity, Revista mexicana de física, 52(2) (2006) 9.
[24] D. I. f. P. Properties, DIPPR Project 801 in: D.I.f.P.P. Research/AIChE (Ed.), 2010.
[25] D.M. Rowe, CRC Handbook of Thermoelectrics, CRC Press, 1995.
[26] E. Saloux, M. Sorin, Explicit model of photovoltaic panels to determine voltages and currents at the maximum power point, Solar Energy, 85(5) (2011) 10.
[27] O. Farhangian Marandi, M. Ameri, B. Adelshahian, The experimental investigation of a hybrid photovoltaic thermoelectric power generator solar cavity-receiver, Solar Energy, 161 (2018) 38-46.
[28] A. Steinfeld, Optimum aperture size and operating temperature of a solar cavity-receiver Solar Energy, 50(1) (1993) 7.